Pivoting

Features

Robust and reliable pivot units to accurately position and/or rotate tooling or parts to work condition.
The P series can be mounted by its rear or front mount and can be used as a DUMP device. By mounting the pivot units by their lateral mounts, they can be used to ROTATE parts, tooling and clamps’ assemblies.

Drive shaft connections are all equipped with robust conical roller bearings for a high load capacity and side load acceptance.

All enclosed mechanism:

 

  • to ensure a high protection degree against contaminants and years of service life without maintenance
  • to minimize downtime associated with contamination

Pneumatic cushioning of both end positions: fixed orifices and integrated cushioning eliminate the need for flow controls and provides for smooth operation in the closing and opening cycles.

Max swivel angle:

Quick set up and changeover: easy removal and a quick changeover which can be achieved in less than a minute.

 

  • COMPLETELY ENCAPSULATED VERSION WHICH SAFEGUARDS THE CLAMP IP INTEGRITY EVEN IF REMOVED
  • EASILY REMOVABLE
  • STEPLESS ORIENTATION OF THE CONNECTOR
  • ALL METAL SENSOR –IP68
  • CE CONFORMITY DECLARATION EMC COMPLIANCE TO EN 60947-5-2:2007 + A1:2012
  • OPTIMAL LED VISUALIZATION FROM EACH ANGULAR ORIENTATION
  • Easy set-up and quick installation time: the orientation of the ports can be easily achieved by untightening the tie rods
  • Remains locked even after loss of air pressure
  • Front, rear and side mounting surfaces
  • Four table mounting positions available
  • 1 sensor for all sizes and opening angle with stepless adjustable connector
  • Extra light products

Manual release button

No external limit stop required

front, rear and side mounting surfaces

All the devices are lubricated for life

All SERIES

P-SERIES

SUBSCRIBE TO OUR NEWSLETTER

Contact Us